TM10-3930-660-20 16-8. FENDERS   -  REPLACE  (Cont’d) b. Pull harness (6) out of grommet (11). Remove grommet (11). REMOVE FENDER (2) FROM BRACES (12) AND  (13). a. b. Remove five carriage bolts (14), five flatwashers (15), five lockwashers (16), and five nuts (17). Discard lockwashers (16). Remove fender (2) from braces (12) and  (13). INSTALLATION 1. INSTALL FENDER (2) ON BRACES (12) AND (13). a. Apply bolts 2. 3. Position fender (2) on braces (12) and  (13). Loctite 242 to threads of carriage (14). Install five carriage bolts (14), five flatwashers (15), and five new lockwashers (16). Install five nuts (17) and torque to 30-35 lb. ft. b. INSTALL WIRING HARNESS (6) AND MOUNTING HARDWARE a. Install grommet (11), and feed harness (6), through grommet (11). b. Position clamp (10) under fender (2)  on  wiring  harness  (6).  Secure clamp (10) with capscrew (9), new lockwasher (8), and nut (7). POSITION LIGHT BRACKET ON FENDER. a. Position light housing (1) on fender (2). Apply Loctite 242 to threads of capscrews (5). 4. b. Secure light housing (1) with four capscrews (5), four new lockwashers (4), and four nuts (3). INSTALL LIGHT ASSEMBLIES AS REQUIRED. Refer to Equipment Condition heading for paragraph numbers of light assembly  removal/installation procedures. 16-13