TM10-3930-660-20 14-11. STEERING SELECT VALVE - REPLACE/REPAIR/TEST (Cont’d) If more than one hydraulic line is to be removed, identify lines to assure proper installation. Use suitable container to catch any hydraulic oil that may drain from  system. 1. TAG AND REMOVE TwO ELECTRICAL LEADS (1) AT PLUGS (2) FROM STEERING SELECT VALVE  (3). a. Tag electrical leads (l). b. Pull plugs (2) from valve (3). 2. TAG AND DISCONNECT FOUR HYDRAULIC HOSES (4) FROM VALVE (3). Note position of valve (3) as mounted on vehicle for use during installation. Note that nuts (5), lockwashers (6), and washers (7), are accessed from inside cab tool box. Lockwashers (9) are located between valve (3) and backside of cab tool box. 3. REMOVE THE STEERING SELECT VALVE (3) FROM VEHICLE. a. Remove two nuts (5), lockwashers (6),  washers  (7),  capscrews  (8), and lockwashers (9), securing valve (3) to the vehicle. Discard lockwashers (6) and lockwashers (9). b. Remove valve (3) from the vehicle. 14-24