TM10-3930-660-20 14-8. STEERING  CYLINDERS   -  REPLACE  (Cont'd) 4. 5* REMOVE NUT (9). REPEAT STEPS 2 THROUGH 4 FOR PARTS (10) THROUGH (12) AT OTHER END OF STEERING CYLINDER (4) AND REMOVE CYLINDER (4) FROM AXLE. INSTALLATION 1. 2. 3. 4. 5. 6. PLACE STEERING CYLINDER BALL JOINT END CAP ASSEMBLY (12) INTO TAPERED HOLE ON AXLE . INSTALL NUT (11). TIGHTEN TO 250 LB. FT. INSTALL NEW COTTER PIN (10). IF NECESSARY, TIGHTEN NUT UNTIL HOLES ALIGN. DO NOT LOOSEN NUT (11) TO INSTALL COTTER PIN (10). PLACE STEERING CYLINDER BALL JOINT END CAP ASSEMBLY (9) INTO TAPERED HOLE AT WHEEL  END. INSTALL NUT (8). TIGHTEN TO 250 LB. FT. INSTALL NEW COTTER PIN (7). IF NECESSARY, TIGHTEN NUT (8) UNTIL HOLES ALIGN. DO NOT LOOSEN NUT (8) TO INSTALL  COTTER  PIN  (7). Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hydraulic components and hoses clean and dry. 7. CONNECT THREE HYDRAULIC HOSES (1), (2) AND (3) AT STEERING CyLINDER (4) AS TAGGED. a. Install tee (5) and adapter (6) to ports of cylinder (4). b. Install hose (3) to adapter (6). c. Install hose (1) and hose (2) to tee (5). 14-16