TM10-3930-660-20 14-8. STEERING  CYLINDERS  -  REPLACE  (Cont'd) The steer cylinder must be adjusted after the knuckle is inspected or after the tie rod is moved to adjust the toe. If more than one hydraulic line is to be removed, identify lines to assure proper installation. Use suitable container to catch any hydraulic oil that may drain from system. 1. 2. 3. TAG AND DISCONNECT THREE HYDRAULIC HOSES (l), (2) AND (3) AT STEERING CYLINDER  (4). a.  Remove tee (5 b. Remove hose (1) and hose (2) from . hose (3) from adapter (6). c. Remove tee (5) and adapter (6) from ports of cylinder (4). ON ONE SIDE OF VEHICLE, REMOVE COTTER PIN (7) AND NUT (8). DISCARD COTTER PIN (7). USING A PICKLE FORK OR EQUIVALENT, SEPARATE STEERING CYLINDER (4) FROM BALL JOINT END CAP ASSEMBLY (9). CAUTION Do not strike nut (8) on side to remove steering cylinder (4). Damage to ball joint end cap assembly (9) may occur. 14-15