TM10-3930-660-20 14-4. STEERING COLUMN -   REPLACE  (Cont’d) INSTALLATION Support steering control valve (1) and steering column (2) as necessary during installation so these parts do not drop prior to installation of capscrew (3) and lockwasher  (4). 1. 2. IF NECESSARY, PUSH STEERING CONTROL VALVE (1) TO ONE SIDE TO PROVIDE ROOM FOR INSTALLATION OF STEERING COLUMN (2) . CAREFULLY POSITION STEERING COLUMN (2) THROUGH ACCESS HOLE AT BASE DASHSOARD AND THROUGH COLUMN HOLE ON DASHBOARD. Hose connections for control valve are on 3. 4. the right side. POSITION STEERING CONTROL VALVE (1) ON STEERING COLUMN (2). TURN STEERING COLUMN SHAFT AS NECESSARY TO ENGAGE SPLINES. INSTALL STEERING COLUMN (2) AND STEERING CONTROL VALVE (l). a. Apply (3) . b. 5. 6. Align capscrew holes on valve (1) and column (2). Loctite 242 to threads of capscrews Secure valve (1) and column (2) to dashboard with four new lockwashers (4) and four capscrews (3). Tighten capscrews (3) in a crisscross pattern to 180 in. lb. INSTALL STEERING WHEEL, PARA. 14-3. INSTALL TURN SIGNAL SWITCH, PARA.  8-13. 14-4