| |
TM10-3930-660-20
10-4.
DRIVE SHAFT ASSEMBLY, TRANSMISSION - REPLACE/REPAIR (Cont'd)
3.
4.
IF NECESSARY, SEPARATE ENGINE AND
TRANSMISSION ENDS OF DRIVE SHAFT
ASSEMBLY (1).
a. Slide engine end of shaft assembly
(1) out of transmission end of
shaft assembly (1). Discard seal
(17) .
b. Remove seal (17) from transmission
end of shaft assembly (l).
IF NECESSARY, REMOVE LUBRICATION
FITTING (18) FROM TRANSMISSION END OF
DRIVE SHAFT ASSEMBLY (l).
ASSEMBLY
1. IF REMOVED, INSTALL LUBRICATION
FITTING (18) TO TRANSMISSION END OF
DRIVE SHAFT ASSEMBLY (l).
20 IF SEPARATED, ASSEMBLE TRANSMISSION
END OF DRIVE SHAFT ASSEMBLY (1) TO
ENGINE END OF DRIVE SHAFT ASSEMBLY
(1) .
a. Position new seal (17) on engine
end of shaft assembly (1).
b. Slide transmission end of shaft
assembly (1) into engine end of
shaft assembly (l).
c. Tighten seal (17) on threads of
transmission end of shaft assembly
(1) .
3. INSTALL UNIVERSAL JOINT (5) TO DRIVE
SHAFT ASSEMBLY (1).
a.
b.
If removed, install fitting (16) to
universal joint (5).
Align universal joint (5) with yoke
(15) on transmission end of shaft
assembly (1).
10-9
|
