TM10-3930-660-20 10-3. PROPELLER SHAFTS, FRONT AND REAR DIFFERENTIAL - REPLACE/REPAIR (Cont’d) INSTALLATION 1. INSTALL PROPELLER SHAFT (1) TO TRANSMISSION (8). a. b. Position shaft (1) so it is partially supported by hook (7) on vehicle frame. Apply Loctite 242 to four capscrews (9). Secure universal joint (11) of shaft (1) to yoke (12) of transmission (8) with four capscrews (9) and four new lockwashers (10). Torque capscrews (9) to 41 lb. ft. 2. INSTALL PROPELLER SHAFT (1) TO AXLE (4)  . a. b. Lift and remove axle end of shaft (1) from hook (7) on vehicle frame. Apply Loctite 242 to four capscrews (2) . Secure universal joint (5)  of shaft (1) to yoke (6) on axle (4) with four capscrews (2) and four new lockwashers (3). Torque capscrews (3) to 41 lb. ft. 30 APPLY GREASE TO LUBRICATION FITTINGS (16), (20), and (22). 4. REMOVE BLOCKING MATERIAL FROM WHEELS. 10-6