| |
TM10-3930-660-20
10-3.
PROPELLER SHAFTS, FRONT AND REAR DIFFERENTIAL - REPLACE/REPAIR (Cont’ d)
d.
e.
f.
2. IF
Remove four capscrews (17) and four
lockwashers (18) securing
universal joint (11) to yoke (19)
on transmission end of shaft (l).
Discard lockwashers (18).
Separate universal joint (11) from
yoke (19).
If necessary, remove lubrication
fitting (20) from universal joint
(11),
NECESSARY, SEPARATE AXLE AND
TRANSMISSION ENDS OF PROPELLER SHAFT
(1) .
a.
b.
3. IF
Turn seal (21) counterclockwise
from axle end of shaft (l).
Slide axle end of shaft (1) out of
transmission end of shaft (l).
Discard seal (21).
NECESSARY, REMOVE LUBRICATION
FITTING (22) FROM AXLE END OF SHAFT
(1) .
ASSEMBLY
1. IF REMOVED, INSTALL LUBRICATION
FITTING (22) TO AXLE END OF
PROPELLER SHAFT (l).
2. IF SEPARATED, INSERT TRANSMISSION END
OF SHAFT (1) INTO AXLE END OF SHAFT
(1) .
a. Carefully position seal (21) on
transmission end of shaft (l).
b. Slide transmission end of shaft
(1) into axle end of shaft (l).
c. Install seal (21) on threads of
axle end of shaft (l).
10-4
|
