TM10-3930-660-20 9-6. TRANSMISSION  DISCONNECT MASTER CYLINDER ASSEMBLY - REPLACE (Cont’d) 2. 3. 4. REMOVE COTTER PIN (4) AND CLEVIS PIN (5) SECURING CLEVIS (6) TO PEDAL ARM (7) . DISCARD COTTER PIN (4) . REMOVE THREE NUTS (8), LOCKWASHERS (9) , AND CAPSCREWS (10) , SECURING MASTER CYLINDER ASSEMBLY (3) TO BRACKET (11) , REMOVE MASTER CYLINDER ASSEMBLY (3) FROM  VEHICLE .  DISCARD LOCKWASHERS (9). REMOVE LINKAGE FROM MASTER  CYLINDER ASSEMBLY  (3). a. b. Loosen jam nut (12) on pushrod pin (13). Remove clevis (6) and jam nut (12) from pushrod pin (13). Loosen jam nut (14) on pushrod pin (13) . Remove pushrod pin (13) from master cylinder assembly (3). Remove jam nut (14) from pushrod pin  (13). INSTALLATION 1. 2. 3. INSTALL LINKAGE TO MASTER CYLINDER ASSEMBLY  (3). DO not tighten parts (6), (12), (13), or (14) at this time. a. Install jam nut (14) on pushrod pin (13) . Install pushrod pin (13) to master cylinder assembly (3). b. Install jam nut (12) and clevis (6) on pushrod pin (13). POSITION MASTER CYLINDER ASSEMBLY (3) ON BRACKET (11) AND SECURE WITH THREE NUTS (8), THREE NEW LOCKWASHERS (9), AND THREE CAPSCREWS (10). REMOVE PLUGS FROM HOLES ON HOSE (1) AND MASTER CYLINDER ASSEMBLY (3). CONNECT HYDRAULIC HOSE (1) AND ADAPTER (2) TO MASTER CYLINDER ASSEMBLY (3). CHECK OIL LEVEL OF MASTER CYLINDER ASSEMBLY (3) AND ADD OIL AS REQUIRED. 9-15