TM10-3930-660-20 9-3. TRANSMISSION SHIFTER -  REPLACE/ADJUST (Cont’d) 4. INSTALL TRANSMISSION CABLE ASSEMBLIES (3) AND (4) TO SHIFTER (1). a. b. c. Position transmission cable assemblies (3) and (4) on shifter (1) under clamps (9) as tagged. Secure cable assemblies (3) and (4) to shifter (1) with clamps (9) and new locknuts (8). Position universal swivels (7) of cable assemblies (3) and (4) on shifter (1) and secure with washers (6) and new cotter pins (5). 5. INSTALL LEFT-HAND INSTRUMENT PANEL AND TRANSMISSION SHIFTER TO FRONT CONSOLE, PARA. 8-6. ADJUSTMENT Shifter adjustment procedures for the travel select cable assembly (3) and the range select cable assembly (4) are essentially similar. Adjustment of the travel select cable assembly is shown in this  section. 1. 2. 3. 4. REMOVE COTTER PIN (5) AND WASHER (6) FROM UNIVERSAL SWIVEL (7) OF CABLE ASSEMBLY  (3).   REMOVE UNIVERSAL SWIVEL (7) FROM SHIFTER (l). DISCARD COTTER PIN (5). LOOSEN JAM NUT (43) AND TURN UNIVERSAL SWIVEL (7) IN OR OUT AS REQUIRED FOR PROPER ADJUSTMENT. TIGHTEN JAM NUT (13) . POSITION UNIVERSAL SWIVEL (7) OF CABLE ASSEMBLY (3) ON SHIFTER (1) AND SECURE WITH WASHER (6) AND NEW COTTER PIN (5). VERIFY THAT SHIFTER (1) OPERATES PROPERLY AND READJUST CABLE ASSEMBLY (3), IF NECESSARY. 5.   INSTALL LEFT-HAND INSTRUMENT PANEL AND TRANSMISSION SHIFTER TO FRONT CONSOLE, PARA. 8-6. 9-5