| |
TM10-3930-660-20
9-3.
TRANSMISSION SHIFTER - REPLACE/ADJUST (Cont’d)
INSTALLATION
1. IF NECESSARY, INSTALL PARTS (13)
THROUGH (42).
a. Secure plate (42) with four
capscrews (40) and four retainers
(41) .
b. Install knobs (39) to levers (35).
c.
d.
e.
f.
9*
h.
i.
Apply grease to items (36), (37), and
(38) as installed.
2.
3*
Install two bearings (38), two
disks (37), two springs (36), and
two levers (35). Secure with two
pins (32), two washers (33), and
two new cotter pins (34).
Secure bracket (31) with two
capscrews (29) and two new
lockwashers (30).
Secure bracket (28) with two
capscrews (26) and two new
lockwashers (27).
Secure bracket (25) with two
capscrews (23) and two new locknuts
(24). Install two capscrews (22).
Repeat step f. for other side of
shifter.
Position back-up alarm switch (17)
on shifter.
Secure with capscrew
(15), washer (16), spacer (18),
washer (19), new lockwasher (20),
and nut (21).
Install washer (14) and new cotter
pin (13).
SUPPORT AND POSITION SHIFTER (1) OVER
FRONT CONSOLE (2).
CONNECT TWO ELECTRICAL LEADS (10) OF
BACK-UP ALARM SWITCH (11) TO VEHICLE
WIRING HARNESS (12) AS TAGGED.
9-4
|
