| |
TM10-3930-660-20
9-3.
TRANSMISSION SHIFTER-
REPLACE/ADJUST (Cont’d)
3. TAG AND DISCONNECT TWO ELECTRICAL
LEADS (10) OF BACK-UP ALARM SWITCH
(11) FROM VEHICLE WIRING HARNESS
(12) .
4. RAISE AND REMOVE SHIFTER (1) FROM
FRONT CONSOLE (2).
5. IF NECESSARY, REMOVE PARTS (13)
THROUGH (42).
a.
b.
c.
d.
e.
f.
h
i
j
.
l
Remove cotter pin (13) and washer
(14) .
Discard cotter pin (13).
Remove capscrew
(15), washer (16),
back-up alarm switch (17), spacer
(18), washer (19), lockwasher (20),
and nut (21).
Discard lockwasher
(20) .
Remove two capscrews (22), two
capscrews
(23), two locknuts (24)’
and bracket (25).
Discard locknuts
(24) .
Repeat step c.
for other side of
shifter.
Remove two capscrews (26), two
lockwashers (27), and bracket (28).
Discard lockwashers (27).
Remove two capscrews (29), two
lockwashers (30), and bracket (31).
Discard lockwashers (30).
Remove two pins (32), two washers
(33), and two cotter pins (34).
Discard cotter pins (34).
Remove two levers (35), two springs
(36), two disks (37)’ and two
bearings (38).
Remove knobs (39) from levers (35).
Remove four capscrews (40), four
retainers (41), and plate (42).
9-3
|
