TM10-3930-660-20 8-47. MAIN  WIRING  HARNESS - TEST/REPAIR/REPLACE (Cont’d) c. Disconnect suspected wire and an adjacent wire. At one end of the wires, connect the two wire terminals together. At the other end of the wires, connect ohmmeter leads to terminals of these two wires at other ends. An infinite resistance reading indicates a broken  wire. REPAIR If 30 percent or more of the wires in a wiring harness have been repaired or replaced, replace complete harness. 1. REPLACE ANY BROKEN TERMINAL RINGS OR CONNECTORS. 2. REPLACE ANY FAULTY WIRES. a. Note both connection points of faulty wire. Disconnect faulty wire at both ends. b. Cut exposed wire and terminals from both ends of faulty wire. c. Cut replacement wire to required length and install proper terminals. d. Route replacement wire along wiring harness, securing wire with tie wraps or electrical tape. e. Connect replacement wire to original connection points. f. Test circuit function. 8-139

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business