TM10-3930-660-20 8-35. REAR TURN SIGNAL LIGHTS - REPAIR/REPLACE (Cont’d) b. Pull lens (12) from socket assembly (13). Remove two (14) from lens (12). c. Pull socket plate assembly from light bracket (15). INSTALLATION plate screws (13) 1. 2. INSTALL SOCKET PLATE ASSEMBLY, LENS, AND MOUNTING HARDWARE. a. b. c. Position socket plate assembly (13) on light bracket (15). Position lens (12) on socket plate assembly  (13). Secure lens (12) and socket plate assembly (13) to light bracket (15) with two screws (14), two new lockwashers (11) and two nuts (10) . CONNECT ELECTRICAL LEADS AT REAR TURN SIGNAL  LIGHT. NOTE One wire lead (6) connected in step “b” below is part of the rear turn signal light assembly (5). The other wire lead (7) is part of the vehicle wiring harness. NOTE Apply Loctite 242 to capscrew (8) as installed. a. b, Install new starwasher (9), two wire leads (6) and (7) as tagged, and second new starwasher (9). Secure with capscrew (8). Connect electrical lead (4) from vehicle wiring harness to rear turn signal light assembly (5) by connecting male plug (3) to female plug  (2). 8-93