| |
TM10-3930-660-20
8-21.
FORK AUTOLEVELER SWITCH - REPLACE/ADJUST (Cont’d)
h.
i.
Pull autoleveler cable (4) tight
from top and secure autoleveler
cable (4) to tube of fork tilt
cylinder (18) with new tie straps
(15), (16) and (17).
Secure autoleveler cable (4) to
NLRS attachment valve cables (14)
with two tie straps (13).
Any slack in autoleveler cable (4) must
be located at boom electrical box end of
cable.
2.
3.
4.
5.
INSTALL MLRS ATTACHMENT VALVE COVER
(8).
a. Secure cover (8) with two
capscrews (10), two new lockwashers
(11), and two nuts (12).
b. Plug two male plugs of vehicle
wiring harness into two female
plugs of light (9) as tagged.
INSERT PLUG ON AUTOLEVELER CABLE (4)
INTO CONNECTOR (7) ON BOOM ELECTRICAL
BOX (5). TURN COLLAR (6) UNTIL CABLE
(4) IS SECURE.
CONNECT NEGATIVE BATTERY CABLE,
PARA. 8-44.
ADJUST AUTOLEVELER SWITCH (l). REFER
TO “ADJUSTMENT OF FORK AUTOLEVELER
SWITCH” SECTION OF THIS PARAGRAPH.
AJMJSTMENT OF FORK AUl13LEVBLER SWI’lX2H
1. REMOVE SWITCH COVER FROM CARRIAGE
ASSEMBLY AS DESCRIBED IN “REMOVAL”
SECTION OF THIS PARAGRAPH.
2. START ENGINE.
3. ADJUST AUTOLEVELER SWITCH (l).
a. Turn on fork autoleveler control
in cab.
8-54
|
