TM10-3930-660-20 8-13. TURN  SIGNAL  SWITCH  -  REPLACEMENT  (Cont’d) INSTALLATION 1. PUSH TURN SIGNAL SWITCH CABLE (7) THROUGH HOLE (C) IN DASHBOARD. a. If removed, install grommet (9). b. From top of dashboard, push turn signal switch cable (7) through hole (c) in dashboard. 2.  CONNECT  WIRING. a. Apply (5)  . b. Connect male connectors (a) of cable (7) to female connectors (b) of vehicle wiring harness (8) as tagged during removal. Loctite 242 to threads of screws Secure dashboard access cover (6) 3. 4. with four screws (5). SECURE TURN SIGNAL SWITCH (3) TO STEERING COLUMN (4). a. Position and support turn signal switch (3) on steering column (4). b. Secure switch (3) with clamp (2) and two screws (l). VERIFY THAT TURN SIGNALS ARE WORKING PROPERLY. a. b. c. Connect negative battery cable, para.  8-44. Turn ignition switch to the “on” position, but do not start the engine. Move turn signal switch lever to the left. Check that turn signals on both front and rear left-hand fenders are flashing. d. e. Move turn signal switch lever to the right. Check that turn signals on both front and rear right-hand fenders  are  flashing. Turn ignition switch off. 8-31