TM10-3930-660-20 --- 5-15. WATER SEPARATOR - REPLACE  (Cont’d) 4. 5. REMOVE Two SCREWS (8) , Two LOCKWASHERS  (9) , BASE (3) , AND TWO STARWASHERS (10) , FROM VEHICLE FRAME. DISCARD LOCKWASHERS (9) AND STARWASHERS  (10)  . IF NECESSARY, REMOVE PARTS FROM BASE (3)  . a. Remove plug kit components (11) from base (3) . b. Remove elbow (7) from base (3) . INSTALLATION 1. IF REMOVED, INSTALL (3)  . a. Install plug kit to base (3). and adapter (5) PARTS TO BASE components  (11) 2. 3. 4. 5. b. Install elbow (7) and adapter (5) to base (3). INSTALL TWO NEW STARWASHERS (10), BASE (3) , TWO NEW LOCKWASHERS (9) , AND TWO SCREWS (8) TO VEHICLE FRAME. INSTALL HOSE (6) TO ELBOW (7)  AT  BASE (3). INSTALL HOSE (4) TO ADAPTER (5) AT BASE (3) . POSITION ELEMENT (2) ON BASE (3) AND SECURE WITH CLAMP (1) . sure clamp (1) is securely engaged in both  slots  of  base  (3)  . - - - 6. BLEED WATER SEPARATOR ASSEMBLY AT TRANSFER  PUMP  (12)  . a. Loosen hose (13) at fitting (14). b. Operate hand lever on transfer pump (12) until fuel flowing from fitting (14) is free of air. c. Tighten hose (13) at fitting (14). 5-34