TM10-3930-660-20 5-13. FUEL DRAIN LINES AND MANIFOLD  -  REPLACE  (Cont’d) If necessary, remove engine lifting bracket, water outlet, and thermostat, as an assembly, to provide access to fuel injector closest to fan side of engine, para.  7-4. 4. 5. REMOVE FLUID PASSAGE BOLT (10) AND SEAL (11) FROM FUEL DRAIN MANIFOLD (12) AT EACH OF THE SIX INJECTORS (13).  DISCARD  SEALS  (11). REMOVE FUEL DRAIN MANIFOLD (12) AND FUEL DRAIN LINES (3) AND (6) FROM TEE (14). Seals (15) are an integral part of lines (3), (6), and (12). Inspect seal (15) at end of each line and replace entire line if seal is damaged. INSTALLATION 1. 2. If INSTALL FUEL DRAIN MANIFOLD (12) AND FUEL DRAIN LINES (3) AND (6) TO TEE (14) . INSTALL FLUID PASSAGE BOLT (10) AND NEW SEAL (11) TO FUEL  DRAIN  MANIFOLD (12) AT EACH OF THE SIX INJECTORS  (13). TORQUE BOLTS (10) TO 6.5 LB. FT. removed to provide access during removal, install engine lifting bracket, water outlet, and thermostat, as an assembly, to engine, para. 7-4. 3. SECURE FUEL DRAIN LINE  (6) TO INJECTION PUMP (9) WITH FLUID PASSAGE BOLT (7) AND TWO NEW SEALING WASHERS (8). TORQUE BOLT (7) TO 32 LB. FT. 4. 5. SECURE FUEL DRAIN  LINE (3) AND FUEL DRAIN LINE MANIFOLD (6) TO ENGINE WITH TWO NEW GROMMETS (5) AND TWO CAPSCREWS (4). TORQUE CAPSCREWS TO 216 LB. IN. SECURE HOSE (2) TO FUEL DRAIN LINE (3) WITH HOSE CLAMP (1). 5-29