TM10-3930-660-20 5-5. AIR CLEANER ASSEMBLY - REPLACE/REPAIR  (Cont’d) 7. REMOVE HOUSING (3) FROM VEHICLE. a. Lift front and rear engine covers (16) and (24), as required, to clear air inlet tube (25) welded to housing  (3). b. Rotate  housing (3), as required,  and remove housing (3) through right-hand engine access door. DISASSEMBLY 1. REMOVE O-RING (33) FROM HOUSING (3). 2. LOOSEN AND REMOVE TWO CLAMPS (23) FROM HOUSING (3). 3. REMOVE ACCESS 4. LOOSEN REMOVE (5). VACUUM DIAPHRAGM (34) FROM COVER  (5). CAPTIVE WING NUT (35) AND BAFFLE (36) FROM ACCESS COVER CLEANING  AND  INSPECTION Refer to Para. 3-4 for cleaning instructions and Para. 3-6 for inspection instructions. ASSEMBLY 1. 2. 3. 4. INSTALL BAFFLE (36) TO ACCESS COVER (5) AND TIGHTEN CAPTIVE WING NUT (35). INSTALL VACUUM DIAPHRAGM (34) TO CUP ASSEMBLY  (5), INSTALL AND TIGHTEN TWO CLAMPS (23) TO HOUSING (3)0 INSTALL O-RING (33) TO HOUSING (3). INSTALLATION Apply Loctite 242 to all capscrews and bolts as they are installed. 1. INSTALL HOUSING (3) TO VEHICLE. 5-10