TM10-3930-660-20 4-10. INTAKE MANIFOLD COVER - REPLACE This task covers: a. Removal b. Installation Initial Setup Tools Materials/Parts Tool Kit, Automotive Mechanics Gasket (4) Loctite #59241 (APP. C, Item 42) Equipment  Condition High pressure fuel lines removed, para.  5-12. Ether start hose disconnected, para.  5-17. Air crossover elbow removed, para.  5-8. 1.   REMOVE INTAKE MANIFOLD COVER (1) FROM ENGINE  (2). a. Remove fourteen capscrews (3) holding manifold cover (1) to engine (2). Two of the fourteen capscrews (3) may be removed with the fuel injection lines. b. Remove manifold cover (1) and gasket  (4).   Discard gasket (4). INSTALLATION 1. 2. 3. CLEAN GASKET SEALING SURFACE ON ENGINE  (2). POSITION NEW GASKET (4) ON ENGINE (2). POSITION INTAKE MANIFOLD COVER (1) ON ENGINE  (2). CAUTION Some of the capscrew holes are drilled through and must be sealed. APPlY Loctite 59241 to the capscrews (3). 4. 5. 6. 7. INSTALL TWELVE CAPSCREWS (3) AND TIGHTEN TO 216 IN. LB. OF TORQUE. INSTALL AIR CROSSOVER ELBOW, PAR. 5-8. CONNECT ETHER START HOSE, PARA. 5-17. INSTALL HIGH PRESSURE FUEL LINES, PARA.  5-12. 4-13/(4-14  blank)