TM10-3930-660-10 a.   Position   the   forks   approximately   24   inches   above   the   ground. When   the   propeller   shafts   are   disconnected   and   the   parking   brake disengaged,  the  vehicle  may  roll  and  could  result  in  severe  personal injury.   Always   chock   the   wheels   properly. b.   Chock   all   wheels. c.   Disconnect   the   rear   axle   steering   cylinder   hoses   as   follows: (1) (2) (3) (4) Remove  the  towing  steer  cylinder  crossover  hose  from  the  dummy  tee  fitting  located  on  the main  frame  crossbar  at  the  rear  of  the  transmission. Disconnect  the  steering  hydraulic  line  from  the  rod  end  tee  fitting  of  the  left  steer  cylinder. Connect  the  line  to  one  side  of  the  dummy  tee  fitting. Disconnect  the  steering  hydraulic  line  from  the  rod  end  tee  fitting  of  the  right  steering  cylinder. Connect  the  line  to  the  other  side  of  the  dummy  tee  fitting. Using  the  steer  cylinder  crossover  hose  from  Step  1,  connect  the  left  and  right  steer  cylinders. Use  open  ports  from  which  hoses  were  removed  in  Steps  2  and  3.  Route  the  hose  so  that  it clears  the  axle  input  yoke. 2-52