TM 10-3930-659-34 3-9.  STE/ICE-R NO-GO CHAIN TESTS - DCA MODE. a. The  following  NO-GO  Chain  Tests  are  made  using  the  forklift  truck’s  DCA  connector.    Each  test  is  referenced from the GO Chain testing sequence.  Do not perform any of these tests  unless  you  are  instructed  to  do  so  by  the  GO Chain testing procedure or by Table 3-1.  All testing is referenced by the NG (NO-GO) number. b. For  normal  readings,  refer  to  the  M544E  Forklift  Truck  Test  Card  at  Table  3-2.    For  DCA  test  location,  refer  to paragraph 3-6. GO Test Page Number Test Title Number NG20 Engine No Crank - No Start Test  .............................................................................................3-34 NG30 Engine Crank - No Start Test ...................................................................................................3-35 NG31 Fuel System Tests....................................................................................................................3-36 NG50 Alternator Tests ........................................................................................................................3-39 NG80 Starter Motor Circuit Tests .......................................................................................................3-41 NG81 Battery Tests ............................................................................................................................3-45 NG90 Starter Motor Tests  ..................................................................................................................3-48 NG100 Engine Tests ............................................................................................................................3-49 NG110 Starter Motor Current Test .......................................................................................................3-51 NG150 Engine Rotation Check.............................................................................................................3-52 3-33