| |
TM 10-3930-659-34
Section II. MANUFACTURING INSTRUCTIONS
1.
Make guide stud from NSN 5305-00-071-1782, Part Number MS90725-129.
2.
Cut off screw head so that stud length is 4 in. (10 cm).
3.
Remove any burrs from stud.
Figure C-1. Flywheel Guide Stud.
1.
Make pipe driver from NSN 4710-01-305-5471, Part Number ASTM A335.
2.
Cut pipe to 5 in. (12.7 cm) length.
3.
Cut ends of pipe square.
4.
Remove any burrs from pipe.
Figure C-2. Fuel Injection Pump Pipe Driver.
TA708030
C-2
|
