43 TM 10-3930-659-34 APPENDIX C ILLUSTRATED LIST OF MANUFACTURED ITEMS Section I.  INTRODUCTION C-1. SCOPE. a. This appendix includes complete instructions for making items authorized to be manufactured or fabricated. b. A cross-reference index is provided for easy location of the item to be manufactured and its fabrication criteria. c.     All bulk materials needed for manufacture of an item are listed by National Stock Number (NSN), part number, or specification number in the manufacturing instructions.  All dimensions given are in standard units. Table C-1.  Manufactured Items Cross-reference Index. Page Figure Number Figure Title Number Figure C-1 Flywheel Guide Stud C-2 Figure C-2 Fuel Injection Pump Pipe Driver C-2 Figure C-3 Turbocharger Turbine Wheel Holding Fixture C-3 Figure C-4 Transmission Output Shaft Pipe Driver C-4 Figure C-5 Transmission Clutch Pack Compression Tool C-4 Figure C-6 Air Deflector Plate C-5 Figure C-7 Transmission Oil Supply Flange Removal Brackets C-6 Figure C-8 Axle Yoke Holding Tool C-7 Figure C-9 Axle Adjusting Tool C-9 Figure C-10 Nonmetallic Seal C-9 C-1