TM 10-3930-659-34 5-17. DIFFERENTIAL ASSEMBLY MAINTENANCE (Con’t). 9. Using puller kit, remove two bearing cones (27 and 39) from housing (28) and cover (41). NOTE Note location of short screw to aid during assembly. 10. Remove eight screws (38), short screw (40), and cover (41) from housing (28). 11. Remove two thrustwashers (30 and 42), shaft (44), and two bevel gears (31 and 43) from housing (28). 12. Remove four thrustwashers (33 and 34), two pinions (35), 26 needle bearings (32), two thrustwashers (36), and retaining rings (37) from shaft (44). 13. Install cover (41) on housing (28) with four screws (38) evenly spaced apart. 14. Place assembly on end with ring gear (29) facing up. 15. Insert wrecking bar through shaft bore in housing (28) and cover (41). 5-168