TM 10-3930-659-34 5-14.  AXLE HOUSING AND PLANETARY CARRIER ASSEMBLY REPAIR (Con’t). NOTE Adding or deleting a 0.005 in.  (0.127 mm) shim will change rolling drag torque by approximately 6 lb.-ft.    (8  N.m).    If  adding  shims,  lift  axle  housing  and  tap  axle  flange  to  remove  any  preload  on bearings. 3 . Adjust two shims (4 and 6) as necessary. 3 . Apply  grease  to  both  sides  of  plate  (9) and install plate over screw (8). 3 .         Using   feeler   gage,   measure   gap   between plate  tang  (32)  and  closest  edge  in  pocket  of planetary  carrier  (5).    Minimum  gap  allowed  is 0.02 in. (0.51 mm). 3 .        Apply    silicone    sealing    compound    to    axle housing (2). 3 . Install ring gear (3) on axle housing (2). 3 . If  removed,  install  lubrication  fitting  (1) on axle housing (2). FOLLOW-ON TASKS: •    Install service brake disc (see paragraph 4-51). •    Install axle housing assembly (see paragraph 4- 50). 5-141