TM 10-3930-659-34 5-14.  AXLE HOUSING AND PLANETARY CARRIER ASSEMBLY REPAIR (Con’t). 23. Install planetary carrier (5) on axle shaft (15) with screw (8).  Torque screw to 145 lb.-ft.  (197 N.m). 24. Rotate planetary carrier (5) at least three times and check the rolling drag torque (see TM 9-214).  Torque must increase 6-12 Ib.-ft.  (8-16 N-m) over reading recorded in step 20.  If rolling drag torque is within specification, go to step 31. 25. Remove planetary carrier (5) from axle shaft (15). 26. Using     outside     caliper     micrometer,     measure thickness  of  two  flattened  pieces  of  lead  (31). Average thickness of two pieces is required shim pack size. NOTE When adding shims, lift axle housing and tap ax a flange to remove any preload on bearings. 27. Install two shims (4 and 6), in sizes determined in step 2(, with thickest shim next to axle shaft (15). 28. Install planetary carrier (5) on axle shaft (15) with screw (I ).  Torque screw to 670 Ib.-ft.  (909 Nem). 29. Rotate axle housing (2) three times and check rolling drag torque (see TM 9-214).  Rolling drag torque must be 6- 12 Ib.-ft.  (8-16 Nnm) over reading made in step 20.  If rolling drag torque is within specification, go to step 31. TA708352 5-140