TM 10-3930-659-34 5-14.  AXLE HOUSING AND PLANETARY CARRIER ASSEMBLY REPAIR (Con’t). e.  AXLE HOUSING ASSEMBLY I 1. Apply silicone sealing compound to outside diameter of new inner seal (20). 2. Install inner seal (20) in axle housing (2), with spring side toward inside of axle housing, until flush with bottom of axle housing bore. 3. Install bearing cup (21) in axle housing (2) until seated against shoulder of axle housing. NOTE When installing outer seal, THIS SIDE OUT must face axle flange. 4. Install new outer seal (14) on axle shaft (15) until flush with bearing cone shoulder on axle shaft. 5. Press bearing cone (13) on axle shaft (15) until seated against bearing cone shoulder. 6. Pack outer seal (14) and bearing cone (13) with grease. NOTE Install seal with sealing lip away from bearing cone. 7. Install new seal (12) on axle shaft (15) until seated against bearing cone (13). 8. Apply grease to face of sealing lip of seal (12). 9. Install bearing cup (19) in axle housing (2) until seated against shoulder of axle housing. 5-138