| |
TM 10-3930-659-34
5-13.
TRANSMISSION OUTPUT SHAFT ASSEMBLY REPLACEMENT.
This Task Covers:
a.
Removal
c. Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Transmission clutch packs and idler gear removed
•
Sealing compound (Item 14, Appendix B)
(see paragraph 5-12).
•
Rags (Item 43, Appendix B)
•
Parking brake removed (see TM 10-3930-659-20).
•
Dry cleaning solvent (Item 47, Appendix B)
•
Two locking straps
Tools/Test Equipment:
•
Two preformed packings
•
General mechanic's tool kit (Item 71, Appendix E)
•
Two seals
•
Electric drill, portable (Item 20, Appendix E)
*Three caps
•
Twist drill set (Item 21, Appendix E)
•
Depth gage micrometer (Item 27, Appendix E)
References:
•
Feeler gage (Item 28, Appendix E)
•
TM 9-214
•
Soft hammer (Item 34, Appendix E)
•
TM 10-3930-659-20
•
Retaining ring pliers (Item 46, Appendix E)
•
Arbor press (Item 47, Appendix E)
General Safety Instructions:
•
Puller kit (Item 50, Appendix E)
•
Dry cleaning solvent is flammable and must not be
•
Transmission output shaft pipe driver (Figure C-4,
used near open flame. Use only in a well-ventilated
Appendix C)
area.
5-121
|