TM 10-3930-659-34 5-6. CYLINDER BLOCK FRONT PLATE REPLACEMENT (Con’t). b.          CLEANING AND INSPECTION I WARNING · Dry  cleaning  solvent,  P-D-680,  is  toxic  and  flammable.    Always  wear  protective  goggles  and gloves, and use only in a well-ventilated area.  Avoid contact with skin, eyes, and clothes, and DO NOT breathe vapors.  DO NOT use near open flame or excessive heat.  The solvent’s flash point is 1000F-1380F  (380C-590C).    If  you  become  dizzy  while  using  cleaning  solvent,  immediately  get fresh air and medical help.  If solvent contacts eyes, immediately wash your eyes and get medical aid. · Compressed  air  used  for  cleaning  or  drying  purposes,  or  for  clearing  restrictions,  should  never exceed 30 psi (207 kPa).  Wear protective clothing (goggles/shield, gloves, etc.) and use caution to avoid injury to personnel. Clean cylinder block front plate and cylinder block with dry cleaning solvent and dry with compressed air.  Remove any remaining gasket material from cylinder block front plate and cylinder block. c.           INSTALLATION I 1. Apply a light coat of Loctite adhesive to cylinder block side of new gasket (2). 2. Install  new  gasket  (2)  and  cylinder  block  front  plate  (3)  on  cylinder  block  (1)  with  five  new  lockwashers  (4)  and screws (5).  Torque screws to 25 lb.-ft.  (34 N-m). FOLLOW-ON TASKS: · Install camshaft (see paragraph 5-5). · Install fuel injection pump and drive gear (see paragraph 4-24). · Install engine oil pump and drive gear (see paragraph 4-19). · Install idler gears (see paragraph 4-8). 5-53