| |
TM 10-3930-659-34
5-6.
CYLINDER BLOCK FRONT PLATE REPLACEMENT.
This Task Covers:
a.
Removal
c.
Installation
b.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
·
Idler gears removed (see paragraph 4-8).
·
Loctite adhesive (Item 2, Appendix B)
·
Engine oil pump and drive gear removed (see
·
Rags (Item 43, Appendix B)
paragraph 4-19).
·
Dry cleaning solvent (Item 47, Appendix B)
·
Fuel injection pump and drive gear removed (see
·
One gasket
paragraph 4-24).
·
Five lockwashers
·
Camshaft removed (see paragraph 5-5).
General Safety Instructions:
Tools/Test Equipment:
·
Dry cleaning solvent is flammable and must not be
·
General mechanic’s tool kit (Item 71, Appendix E)
used near open flame. Use only in a well-ventilated
·
Compressor unit (Item 16, Appendix E)
area.
·
Torque wrench, 0-175 lb.-ft. (Item 81, Appendix E)
·
Compressed air used for cleaning purposes should
never exceed 30 psi (207 kPa).
a. REMOVAL
Remove five screws (5), lockwashers (4), cylinder block front plate (3), and gasket (2) from cylinder block (1).
Discard lockwashers and gasket.
5-52
|
