TM 10-3930-659-34 5-2. CYLINDER LINERS MAINTENANCE (Con’t). d. INSTALLATION CAUTION •  Engine  block  bore  and  counterbore  must  be  clean  or  cylinder  liner  will  not  seat  properly  and damage to   parts may result. •  DO  NOT  use  excessive   force   when   installing   cylinder   liner.   Cylinder   liner   flange   may   be damaged. 1. Using wood block and ball-peen hammer, install cylinder liner (4) in engine block (1). 2. Using  dial  indicator  and  height  gage,  measure  height  of  cylinder  liner  (4)  from  engine  block  (1)  at  four  equally spaced points around cylinder liner. Measurement must not exceed 0.004 in. (0.102 mm). 3. Using cylinder liner puller, remove cylinder liner (4) from engine block (1). 4. Install new preformed packing (9) on cylinder liner (4). 5. Install two new preformed packings (10) in engine block (1). Ensure that preformed packings do not stick out of grooves in engine block. CAUTION Install cylinder liner in engine block slowly. Failure to do so may twist preformed packings and cause damage to parts. NOTE Cylinder  liners  will  extend  above  engine  block  more  than  normal  because  preformed  packings have not been compressed. 6. Apply lubricating oil to cylinder sleeve. Slide cylinder liner (4) in engine block (1). 7. Using wood block and ball-peen hammer, tap cylinder liner (4) into engine block (1). 8. Remove flywheel turning tool (6) from engine (1). TA708133 5-19