| |
TM 10-3930-659-34
4-61. CAB ASSEMBLY WITH ROPS REPLACEMENT (Con’t).
4.
Remove four resilient mounts (5) from cab assembly (2).
5.
Lower cab assembly (2) to ground and remove suitable lifting device.
6.
Remove four nuts, screws, and lifting brackets from cab assembly (2).
b. INSTALLATION
1.
Install four lifting brackets on lifting eyes (1) with four j in. x 212 in. x 13 screws and nuts. Attach suitable lifting
device to lifting brackets and raise lifting device enough to support weight of cab assembly (2).
WARNING
Use extreme caution when handling heavy parts. Lifting device is required when parts weigh over
50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two person lift, and over 150 lb (68 kg)
for a three or more person lift. Keep clear of heavy parts supported only by lifting device. Failure
to follow this warning may cause serious injury or death to personnel.
NOTE
Cab weighs 1650 lb (750 kg).
2.
Using suitable lifting device, raise cab assembly (2) and install four resilient mounts (5).
3.
Position cab assembly (2) on frame (6). Ensure that all hoses and linkages are clear.
4.
Install four resilient mounts (7), eight washers (8 and 9), four screws (6), washers (4), and nuts (3). Torque nuts to
235 lb.-ft. (319 N.m).
5.
Remove suitable lifting device and lifting brackets from cab assembly (2).
6.
Remove four nuts, screws, and lifting brackets from cab assembly (2).
FOLLOW-ON TASKS:
• Connect front windshield and rear window washer (see TM 10-3930-659-20).
• Connect parking brake cable (see TM 10-3930-659-20).
• Install brake valves (see TM 10-3930-659-20).
• install steering valve (see TM 10-3930-659-20).
• Connect brake light switch (see TM 10-3930-659-20).
• Install transmission shift cables (see TM 10-3930-659-20).
• Install transmission shift linkage (see TM 10-3930-659-20).
• Install accelerator cable (see TM 10-3930-659-20).
• Install forklift control valve (see TM 10-3930-659-20).
• Connect forklift control valve levers (see TM 10-3930-659-20).
• Connect under cab wiring harness (see TM 10-3930-659-20).
• Connect outside cab heater hoses (see TM 10-3930-659-20).
• Install cab ground strap (see TM 10-3930-659-20).
• Install cab skirts (see TM 10-3930-659-20).
4-233
|