TM 10-3930-659-34 4-50. AXLE HOUSING ASSEMBLY REPLACEMENT (Con’t). 7. Repeat steps 3 through 6 to ensure accurate measurement. 8. Axle shaft should not move more than 0.015 in.  (0.381 mm).  If axle shaft movement exceeds specification, replace axle housing (1). b. REMOVAL NOTE All  four  axle  housing  assemblies  are  removed  the  same  way.    One  axle housing assembly is illustrated. 1. Remove axle assembly (see paragraph 4-47 or 4-48). WARNING Axle  housing  weighs  approximately  270  lb  (123  kg).    Use  suitable  lifting device  and  assistants  to  lift  axle  housing.    Failure  to  follow  this  warning may result in injury to personnel. NOTE When  axle  housing  is  removed,  brake  disc  and  drive  shaft  may  fall  out  or stay with axle housing. 2. Mark axle housing (1) and differential case (6) to aid during installation. 3. Remove 12 screws (4), washers (5), and axle housing (1) from differential case (6). 4-183