TM 10-3930-659-34 4-33. CONVERTER STALL TEST. This Task Covers: Stall Test Initial Setup: Equipment Conditions: Tools/Test Equipment: • Clutch cutoff switch disengaged (see TM 10-3930- • STE/ICE (Item 58, Appendix E) 659-10). References: • TM 10-3930-659-10 STALL TEST 1.    Connect STE/ICE to read engine rpm (see paragraph 3-4). 2.    Hold down service brake pedal. 3.    Move transmission speed range selector lever to fourth gear and hold down service brake pedal (see TM 10-3930- 659-10).  Engine should stall at 2100 rpm. 4.    If engine stall speed is excessively low, perform STE/ICE engine power check (see STE/ICE-R Test G06). 5.    Repeat steps 2 and 3. 6.    If engine stall speed is still low, replace torque converter (see paragraph 4-38). 7.    If engine stall speed is excessively high, replace torque converter (see paragraph 4-38). 4-142