TM 10-3930-659-34 4-30. CONVERTER-OUT PRESSURE TEST (Con’t). NOTE Perform steps 7 through 9 only If pressure reading was above 100 psi (690 kPa) in step 6. 7. Check for pinched or blocked hoses between torque converter and transmission oil cooler. 8. Remove transmission thermal bypass valve and check for restrictions (see TM 10-3930-659-20). 9. Remove  transmission  suction  tube  and  check  for  restrictions  in  transmission  suction  tube  screen  (see  TM  10- 3930-659-20). NOTE Perform steps 10 and 11 only if pressure was below 70 psi (483 kPa) in step 6. 10. Perform converter relief valve pressure check (see paragraph 4-32). 11. Check for leaking torque converter.  If leaking, replace torque converter (see paragraph 4-38). 12. Remove pressure gage (3) and hose (4) from adapter (2). 13. Remove  adapter  (2)  and  preformed  packing  (1)  from  transmission  oil  temperature  sender  port  (5).    Discard preformed packing. 14. If pressure reading still is not within specification, replace transmission assembly (see paragraph 4-40). FOLLOW-ON TASKS: · Install transmission oil temperature sender (see TM 10-3940-659-20). · Install right transmission side guard (see TM 10-3930-659-20). · Remove frame locking bar (see TM 10-3930-659-10). 4-133