TM 10-3930-659-34 4-24. FUEL INJECTION PUMP REPLACEMENT. This task covers: a. Setting to Top Dead Center (TDC) c. Installation b. Removal INITIAL SETUP: Equipment Conditions: Materials/Parts: • Fuel injection pump terminal leads removed (see • Rags (Item 43, Appendix B) TM 10-3930-659-20) • Two gaskets • Accelerator cable and spring removed (see TM 10-    • Three lockwashers 3930-659-20). • Fuel injection pump-to-fuel tank fuel line and fittings removed (see TM 10-3930-659-20). Personnel Required: Two • Fuel filter housing-to-fuel injection pump fuel line and fittings removed (see TM 10-3930-659-20). References: • Leak-off tubes and fuel lines removed (see para- • TM 10-3930-659-20 graph 4-22). Tools/Test Equipment: General Safety Instructions: • General mechanic's tool kit (Item 71, Appendix E) •DO NOT perform this procedure near fire, flames, or • Flywheel turning tool (Item 25, Appendix E) sparks. • Timing pin (Item 69, Appendix E) • Fuel injection pump shaft removal tool (Item 53, Appendix E) • Torque wrench, 0-300 lb.-in Item 80, Appendix E) • Torque wrench, 0-175 lb.-ft Item 81, Appendix E) • Fuel injection pump pipe driver (Figure C-2, Appen- dix C) WARNING Diesel fuel is combustible.  DO NOT smoke or allow open flame near fuel injection pump.  Failure to  follow  this  warning  will  result  in  death  or  serious  injury  to  personnel.    If  you  are  burned, immediately seek medical aid. 4-93