| |
TM 10-3930-659-20
17-33. FORK SPACING CYLINDER REPLACEMENT.
This Task Covers:
a.
Removal
b.
installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Parking brake set (see TM 10-3930-659-10).
• Grease (Item 23, Appendix C)
•
Forks positioned fully apart and resting on ground
• Rags (Item 27, Appendix C)
(see TM 10-3930-659-10).
• Marker tags (Item 33, Appendix C)
• Two locknuts
• Four springpins
Tools/Test Equipment
•
General mechanic's tool kit (Item 44, Appendix F)
References:
• TM 10-3930-659-10
NOTE
•
All hoses and lines should be tagged before removal. Refer to paragraph 2-18 for
tagging Instructions.
•
A suitable container should be used to catch any draining hydraulic fluid. Ensure
that all spills are properly cleaned.
a.
REMOVAL
1.
Loosen two locknuts (6 and 12).
2.
Remove two hoses (11) from lines (3).
NOTE
Perform step 3 only If fork spacing cylinder Is not operational.
3.
Remove two locknuts (6 and 12) and chains (1 and 8) from forks (4 and 7). Discard locknuts.
4.
Remove four springpins (9) and two pins (2) from fork spacing cylinder (10). Discard springpins.
5.
Remove fork spacing cylinder (10) from carriage assembly (5).
6.
Remove fork spacing cylinder hoses, lines, and fittings (see paragraph 17-26).
17-100
|