TM 10-3930-659-20 17-14.    FORK/BRAKE HYDRAULIC PUMP OUTLET-TO-FORKLIFT CONTROL VALVE HOSE REPLACEMENT. This task covers: a. Removal b. Installation INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Parking brake set (see TM 10-3930-659-10). • Rags (Item 27, Appendix C) •    Frame locking bar Installed (see TM 10-3930- • Seven preformed packings •    Right side cab skirt removed (see paragraph    Tools/Test Equipment 14-6). •    Right transmission side guard removed (see • General mechanic's tool kit (Item 44, Appendix F) paragraph 14-7). • Accumulator-to-fork/brake hydraulic pump References: hose and • TM 10-3930-659-10 fittings removed (see paragraph 10-15). NOTE A  suitable  container  should  be  used  to  catch  any  draining  hydraulic  fluid. Ensure that all spills are properly cleaned. a. REMOVAL 1. Remove hose (13) and preformed packing (16) from forklift control valve (1).Discard preformed packing. 2. Remove hose (13) and preformed packing (12) from tee (11).Discard preformed packing. 3. Remove tube nut (3), reducer (2), preformed packing (4), fitting (15), and preformed packing (14) from tee (11). Discard preformed packings. 4. Remove tee (11) and preformed packing (8) from tee (7).Discard preformed packing. 5. Remove tee (7) and preformed packing (5) from reducer bushing (6).Discard preformed packing. 6. Remove reducer bushing (6) and preformed packing (9) from fork/brake hydraulic pump (10).Discard preformed packing. b. INSTALLATION 1. Install new preformed packing (9) and reducer bushing (6) on fork/brake hydraulic pump (10). 2. Install new preformed packing (5) and tee (7) on reducer bushing (6). 3. Install new preformed packing (8) and tee (11) on tee (7). 4. Install new preformed packing (14), fitting (15), preformed packing (4), tube nut (3), and reducer (2) on tee (11). 17-52