TM 10-3930-659-20 12-3. STEERING COLUMN MAINTENANCE (Con't). 3. Loosen two screws (14) and remove steering support (13) from shaft (15) and column (12). b. DISASSEMBLY NOTE • Access to springpins is through hole In steering column housing. • Steering column Is not repairable.  If damaged It must be replaced. 1. Remove three springpins (17) and steering shaft (1) from universal joint (18).  Discard springpins. 2. Remove three springpins (16) and universal joint (18) from shaft (15).  Discard springpins. 3. Remove spring (9) from steering column latch (10). 4. Remove pad (11) from steering column latch (10). 5. Remove springpin (8) from steering column latch (10).  Discard springpin. c. ASSEMBLY 1. Install new springpin (8) on steering column latch (10). 2. Install pad (11) on steering column latch (10). 3. Install spring (9) on steering column latch (10). 4. Install universal joint (18) on shaft (15) with three new springpins (16). 5. Install steering shaft (1) on universal joint (18) with three new springpins (17). d. INSTALLATION 1. Position steering support (13) and shaft (15) on column (12), and install two screws (14).  Torque screws to 2. Position steering shaft (1) so that notches in extension (6) are engaged with springpin (8). 3. Move steering shaft (1) through full range of pivot travel.  Ensure that in forward position, steering shaft does not hit dash panel.  If it does, repeat step 2. 4. Install steering column latch (10) and steering plate (4) on bracket (7) and steering shaft (1) with three screws (5) and new locknuts (3). 5. Connect spring (9) on steering column pin (2). 12-10