TM 10-3930-659-20 7-14. TRANSMISSION OIL COOLER REPLACEMENT (Con't). b. INSTALLATION WARNING Use  extreme  caution  when  handling  heavy  parts.    Lifting  device  Is  required when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for  a  two  person  lift,  and  over  150  lb  (68  kg)  for  a  three  or  more  person  lift. Keep clear of heavy parts supported only by lifting device.  Failure to follow this warning may cause serious Injury or death to personnel. 1. Install transmission oil cooler (7) and reverse warning alarm bracket (6) on bracket (16) with three washers (5) and screws (4). 2. Position hydraulic reservoir-to-transmission oil cooler hose (13) on transmission oil cooler (7) and tighten clamp (14). 3. Position  hydraulic  system  return  filter-to-transmission  oil  cooler  hose  (11)  on  transmission  oil  cooler  (7)  and tighten clamp (15). 4. Position  transmission  oil  cooler  bypass  hose  (12w  on  transmission  oil  cooler  m  and  tiahten  clamp  (9{.  tighten clamp (8). 6. Install eight washers (3) and screws (2) on engih radiator shroud (1). FOLLOW-ON TASKS: • Install reverse warning alarm (see paragraph 6-39). • Install radiator grille housing (see paragraph 5-32). • Fill hydraulic reservoir with hydraulic fluid (so TM 10-3930-659-10). • Check transmission fluid level and fill as necessa (see TM 10-3930-659-10). • Start engine and check for leaks (see TM 10-393 659-10). • Shut down engine (see TM 10-3930-659-1( Check hydraulic reservoir and transmission flu levels and fill as necessary (see TM 10- 393 659-10). TA707351 7-45