TM 10-3930-659-20 7-10. TRANSMISSION CLUTCH CUTOFF VALVE PRESSURE TEST. This task covers:  Pressure Test INITIAL SETUP: Equipment Conditions: Materials/Parts: • Parking brake set (see TM 10-3930-659-10). • Two preformed packings • Frame locking bar Installed (see TM 10-3930- 659-10). Personnel Required:  Two • Right side cab skirt removed (see paragraph 14-6). • Right transmission side guard removed (see paragraph 14-7). References: • TM 10-3930-659-10 Tools/Test Equipment: • General mechanic's tool kit (Item 44, Appendix F) • Adapter (Item 1, Appendix F) • Adapter (Item 2, Appendix F) • Pressure gage (Item 18, Appendix F) • Hose assembly (Item 20, Appendix F) • Multimeter (Item 22, Appendix F) • Tee (Item 37, Appendix F) PRESSURE TEST NOTE Step 1 checks resistance of coil.  Resistance must be checked before performing pressure test. 1. Disconnect wiring harness connector (2) from solenoid connector (1) and check resistance of (3).  Resistance should be 8.5-9.5 ohms.  If resistance Is not within specification, replace coil ( paragraph 7-11). TA707337 7-26