TM 10-3930-659-20 7-3. TRANSMISSION SHIFT RODS REPLACEMENT (Con’t). NOTE Speed  range  selector  lever  and  direction  selector lever  are  different  sizes.    Note  position  of  levers  to aid during Installation. 6. Remove  screw (25) and bellcrank (24) from speed range selector lever (29). 7. Remove screw (26) and bellcrank (22) from direction selector lever (1). 8. Remove two indicator springpins (11) from direction selector lever (1) and speed range select lever (29).  Discard indicator springpins. 9. Remove two screws (13) and cover (2) from steering column flange (19). 10. Remove two keys (23) from direction selector Iever (1) and speed range selector lever (29). 11. Remove direction selector lever (1) and speed range selector lever (29) from steering column flange (19). NOTE Perform  steps  12  through  15  only  If  bushings  or bearings are damaged. 12. Drive out springpin (15) and remove direction bushing (14) from direction selector lever (1).  D card springpin. 13. Drive out springpin (28) and remove speed bushing (27) from speed range selector lever (29).  D card springpin. 14. Remove four nuts (18), screws (17), and two upper bearings (16) from steering column flange (19). 15. Remove four screws (20) and two lower bearings (21) from cab floor. TA707327 7-10