TM 10-3930-659-20 6-69. STE/ICE TURN SIGNAL/EMERGENCY FLASHERS AND BLACKOUT LIGHTS WIRING HARNESS MAINTENANCE. This task covers: a. Repair c Installation b. Removal INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Negative battery cables disconnected (see- • Marker tags (Item 33, Appendix C) paragraph 6-43 • Cab skirts removed (see paragraph 14-6). Tools/Test Equipment: •    Front turn signal/emergency flashers and front    • General mechanic's tool kit (Item 44, Appendix F) black out lights removed (see paragraph 6-22). •    Blackout driving light removed (see paragraph 6-23). NOTE •  All  wires  should  be  tagged  before  removal.    Refer  to  paragraph  2-18  for tagging Instructions. • Refer to wiring diagrams for assistance (see paragraph 6-73). a. REPAIR NOTE •  STE/ICE  turn  signal/emergency  flashers  and  blackout  lights  wiring  harness does not need to be removed from forklift truck to perform repair. • Repair of STE/ICE turn signal/emergency flashers and blackout lights wiring harness   consists   of   replacement   of   identification   bands,   terminals,   and connectors. Refer to paragraph 2-28 for repair instructions. b. REMOVAL NOTE Remove clamps as necessary. 1. Disconnect  STE/ICE  turn  signal/emergency  flashers  and  blackout  lights  wiring  harness  connector  (2)  from STE/ICE chassis wiring harness connector (1). 2. Remove STE/ICE turn signal/emergency flashers and blackout lights wiring harness from forklift truck. 6-268