TM 10-3930-659-20 6-66. STE/ICE LOAD CENTER WIRING HARNESS MAINTENANCE. This task covers: a. Repair c Installation b. Removal INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Negative battery cables disconnected • Marker tags (Item 33, Appendix C) (see paragraph 6-43). •    Right access door opened (see TM 10-3930-    References 659-10). Tools/Test Equipment: • TM 10-3930-659-10 •    General mechanic's tool kit (Item 44, Appendix F) NOTE •  All  wires  should  be  tagged  before  removal.    Refer  to  paragraph  2-18  for tagging Instructions. • Refer to wiring diagrams for assistance (see paragraph 6-73). a. REPAIR NOTE •  STE/ICE  load  center  wiring  harness  does  not  need  to  be  removed  from forklift truck to perform repair. •  Repair  of  STE/ICE  load  center  wiring  harness  consists  of  replacement  of Identification bands, terminals, and connectors. Refer to paragraph 2-28 for repair Instructions. b. REMOVAL NOTE Remove tie-down straps as necessary. 1. Remove two nut fasteners (2), screws (1), and resistor assembly (3) from cab (4). 6-246