TM 10-3930-659-20 2-28. ELECTRICAL REPAIR (Con't). i. Plug Connector Repair. (1) Remove   wire   lead   (22)   from   plug connector (24). (2) Cut  insert  (23)  off  wire  lead  (22)  and discard. (3) Remove Insulation from wire lead (22) equal to depth of new Insert (23). (4) Position  new  Insert  (23)  on  wire  lead (22) and crimp (Item 43, Appendix F). (5) Press  insert  (23)  into  plug  connector (24) until fully seated. (6) Pull on wire lead (22) slightly to ensure that insert (23) is locked in place. j. Connector Body Contact Replacement. (1) Cut contact (27) and cable seal (26) off wire lead (25).  Discard contact. (2) Remove approximately Y In.  (6 mm) of insulation from wire lead (25). (3) Aline   cable   seal   (26)   with   edge   of insulation on wire lead (25). (4) Position new contact (27) on wire lead (25) and crimp (Item 43, Appendix F). (5) Position cable seal (26) over wire lead (25) and contact (27). TA706729 2-24