TM 10-3930-659-20 6-57. STE/ICE ALTERNATOR, STARTER MOTOR, AND FUEL INJECTION PUMP WIRING HARNESS MAINTENANCE. This task covers: a. Repair c. Installation b. Removal INITIAL SETUP: Equipment Conditions: Materials/Parts: •    Negative battery cables disconnected (see para- • Marker tags (Item 33, Appendix C) graph 6-43). • One locknut •    Conveyorized fork attachments removed from side of • Six lockwashers forklift truck (see paragraph 17-13). •    Right and left engine upper sideshields opened (see References: TM 10-3930-659-10). Tools/Test Equipment: • TM 103930659-10 •    General mechanic's tool kit (Item 44, Appendix F) NOTE • All cables and wires should be tagged before removal.  Refer to paragraph 2- 18 for tagging Instructions. • Refer to wiring diagrams for assistance (see paragraph 6-73). a. REPAIR NOTE •  STE/ICE  alternator,  starter  motor,  and  fuel  Injection  pump  wiring  harness does not need to be removed from forklift truck to perform repair. •  Repair  of  STE/ICE  alternator,  starter  motor,  and  fuel  Injection  pump  wiring harness   consists   of   replacement   of   Identification   bands,   terminals,   and connectors. Refer to paragraph 2-28 for repair instructions. b. REMOVAL NOTE Remove clamps and tie-down straps as necessary. 1. Disconnect four STE/ICE alternator, starter motor, and fuel Injection pump wiring harness connectors (1) from engine frame wiring harness connectors (2). 6-182