TM 10-3930-659-20 6-54. CLUTCH CUTOFF MICROSWITCH REPLACEMENT. This task covers: a. Removal b. Installation Initial Setup Equipment Conditions: Materials/Parts: • Battery disconnect switch in OFF position • Marker tags (Item 33, Appendix C) (see TM 10-3930-659-10). • Two locknuts References: Tools/Test Equipment: *TM 10-3930-659-10 • General mechanic's tool kit (Item 44, Appendix F) a. REMOVAL NOTE All wires should be tagged before removal.  Refer to paragraph 2- 18 for tagging Instructions. 1. Remove two screws (3), two under cab wiring harness terminal leads (4), and suppressor wires (5) from clutch cutoff microswitch (6). 2. Remove two locknuts (7), screws (1), clutch cutoff microswitch (6), and two washers (8) from bracket (2). Discard locknuts. b. INSTALLATION 1. Install two washers (8) and clutch cutoff microswitch (6) on bracket (2) with two screws (1) and new locknuts (7). 2. Install two suppressor wires (5) and two under cab wiring harness terminal leads (4) on clutch cutoff microswitch (6) with two screws (3). 6-176