TM 10-3930-659-20 6-43. BATTERY CABLES REPLACEMENT (Con't). a. REMOVAL NOTE Battery cables should be tagged and routing noted before removal. Refer to paragraph 2-18 for tagging instructions. 1. Remove nut (20), STE/ICE batteries and blackout lights wiring harness terminal lead (19), and negative (-) battery cable (11) from negative (-) terminal of left battery (18). 2. Remove screw (13), lockwasher (12), and negative (-) battery cable (11) from shunt (10).  Discard lockwasher. 3. Remove negative (-) battery cable (11) from forklift truck and remove conduit from battery cable.  If damaged, discard conduit. 4. Pull back cover (15), and remove nut (17) and positive (+) end of battery cable (14) from positive (+) terminal of left battery (18). 5. Remove tie-down strap (16) and cover (15) from positive (+) end of battery cable (14). 6. Pull back cover (8), and remove nut (7) and negative (-) end of battery cable (14) from negative (-) terminal of right battery (21). 7. Remove tie-down strap (9) and cover (8) from negative (-) end of battery cable (14). 8. Remove battery cable (14) from forklift truck and remove conduit from battery cable.  If damaged, discard. 9. Pull back cover (5), and remove nut (6) and positive (+) battery cable (22) from positive (+) terminal of right battery (21). 10. Remove tie-down strap (4) and cover (5) from positive (+) battery cable (22). NOTE Cable from starter to slave receptacle, wires of engine frame wiring harness, and wires of engine wiring harness are removed as positive (+) battery cable Is removed. 11. Pull back cover (3), and remove nut (2) and positive (+) battery cable (22) from starter motor solenoid (1). 12. Remove cover (3) from positive (+) battery cable (22). 13. Remove positive (+) battery cable (22) from forklift truck and remove conduit from battery cable.  If damaged, discard conduit. b. INSTALLATION 1. Install conduit on positive (+) battery cable (22) and route battery cable between starter motor solenoid (1) and positive (+) terminal of right battery (21). 6-152