TM 10-3930-659-20 6-25. TAILLIGHT AND REAR TURN SIGNAL/EMERGENCY FLASHERS MAINTENANCE (Con't). 3. Install new lamp (4) in socket (6) by pushing lamp in and turning clockwise. CAUTION Use  care  not  to  overtighten  screws  when  Installing  lens.    Lens  Is  plastic  and  may  be damaged If screws are overtightened. 4. Install lens (3) on housing (5) with two plastic washers (2) and screws (1). b. REMOVAL • Left  and  right  taillights  and  rear  turn  signal/emergency  flashers  are  removed  and Installed the same way.  Left taillight is illustrated. • For  access  to  clamps,  light  plate  holding  taillights  and  rear  turn  signal/emergency flashers must be lowered from radiator grille housing. 1. Remove four screws (12) and washers (11), and slightly lower light plate (7) from radiator grille housing (8). 2. Disconnect taillight connector (10) from rear frame wiring harness connector (9). NOTE Remove clamps as necessary. 3. Remove two flange nuts (13) and light assembly (14) from light plate (7). TA707800 6-114